No heat or lukewarm air
The furnace runs but the air never gets properly hot, or it will not start at all. Ignition failures, a dead blower motor or a tripped safety switch are common causes our technicians can usually fix the same visit.
Tulsa winters do not get the headlines that our summers do, but anyone who lived through an Oklahoma ice storm knows a dead furnace in January is a genuine emergency. When you need furnace repair in Tulsa, you need two things: heat restored quickly, and the confidence that the repair was done safely — because a gas furnace is a combustion appliance, and shortcuts are not an option.

Green Country Heating & Air repairs gas furnaces across Tulsa and Green Country, from workhorse units in Sapulpa's older homes to high-efficiency condensing furnaces in new Broken Arrow subdivisions. Every repair starts with a full safety and performance check: ignition, flame sensor, heat exchanger condition, venting and carbon monoxide testing before we leave your home.
The furnace runs but the air never gets properly hot, or it will not start at all. Ignition failures, a dead blower motor or a tripped safety switch are common causes our technicians can usually fix the same visit.
A furnace that fires up and shuts off every few minutes is overheating, starved for airflow or fighting a faulty flame sensor. Left alone, short cycling cracks heat exchangers over time — the one furnace part you never want to fail.
A healthy gas flame is steady and blue. A yellow, lazy or flickering flame can mean incomplete combustion and carbon monoxide production. Turn the system off and call for service — this one is a safety issue, not a comfort issue.
A boom at startup can be delayed ignition; rattles are often loose panels or duct expansion; squealing points at blower bearings or a belt. Each noise tells a story, and catching it early is almost always cheaper.
If your CO alarm sounds, or family members get headaches and nausea that ease outdoors, leave the house and call emergency services first, then us. A cracked heat exchanger can leak CO into your air stream and must be ruled out before the furnace runs again.
When some rooms stay cold and your ONG bill climbs, the furnace may be losing efficiency to a dirty burner, failing blower or duct leaks. A repair visit restores both comfort and the efficiency you are paying for.
We start with combustion safety: heat exchanger inspection, venting check and CO testing around the unit before any repair work begins.
Igniters, flame sensors, inducer motors, boards — we test components in sequence, find the failed part, and quote one flat price for approval before the repair.
After the repair we run the furnace through full heating cycles, verify temperature rise is within the manufacturer's range and re-check CO levels.
A surprising share of furnace failures trace back to a choked filter or blocked return. We check both and show you the right filter size and change interval for your system.
If your furnace is nearing the end of its life, we will say so and explain the signs we saw — and if it has years left, we will say that too.
Most furnace repairs in the Tulsa area run between about $250 and $750 depending on the part: igniters and flame sensors at the low end, inducer and blower motors in the middle, control boards higher. The exception is a cracked heat exchanger — on an older furnace that diagnosis usually means replacement is the safe and economical answer, and we will document exactly what we found with photos before recommending it.
Gas furnaces typically last 15 to 20 years in Oklahoma homes. If yours is in that range and needs a major repair, we will quote the repair and a replacement side by side so the decision is yours, made with real numbers — never under pressure while your house is cold.
Heating repair is where trust matters most, because most homeowners cannot see what we see inside the cabinet. We show you the failed part, explain the test that condemned it, and put the flat price in writing before we start. That is how furnace repair in Tulsa should work.
Ready when you are: call (918) 555-0100 for furnace repair anywhere in Tulsa, Broken Arrow, Owasso, Bixby, Jenks and the rest of Green Country.
Most repairs fall between roughly $250 and $750 depending on the failed part — igniters and sensors at the low end, motors and control boards higher. We diagnose first, then give you one flat price to approve before any work begins.
That is short cycling, usually caused by overheating from restricted airflow (dirty filter or blower problems), a faulty flame sensor, or a failing limit switch. It needs diagnosis soon — repeated overheating stresses the heat exchanger, the most safety-critical part of the furnace.
Signs include a flickering yellow flame, soot around the burner, unusual smells, or a carbon monoxide alarm. Only a technician's inspection and CO test can confirm it. A cracked heat exchanger means the furnace should not run until it is repaired or replaced.
A well-maintained gas furnace typically lasts 15 to 20 years. Tulsa's winters are milder than our summers are hot, so furnaces here often outlast the air conditioner they are paired with — but age plus a major repair bill usually tips the decision to replacement.
Yes. Heating failures during cold snaps are treated as emergencies across Tulsa and Green Country, and we answer around the clock. If you smell gas, leave the home and call 911 or your gas utility first, then call us.
Same-day appointments across Tulsa and Green Country, up-front pricing before any work begins, and a real person on the phone 24/7 for emergencies.